Published On Dec 25, 2020
Using 3d Printed textiles, I made my version of an Ugly Christmas Sweater. In this video, I take you step by step through my process which is a good outline for how to make your own garments. Total print time of this garment was approximately 120 hours.
SUBSCRIBE TO MY CHANNEL (it’s free): / @sewprinted
INSTAGRAM: / sewprinted
_____________________________
5 Ways to 3d Print Fabric: • 5 Ways to 3D Print Fabric | Experimen...
Software Used:
- AutoCad
- Rhinoceros
- Cura (slicer)
Filament:
- FilaFlex 82A by Recreus
Printer:
- Artillery Sidewinder X1: https://www.amazon.com/Artillery-Side...
Print Settings:
Layer height: 0.2mm
Wall Thickness: 1mm
Wall line count: 3
Top/Bottom Thickness: 0
Top Thickness: 0
Top Layers: 0
Bottom Thickness: 0
Bottom Layers: 0
Infill Density: 60%
Infill Pattern: Gyroid
Print Temp: 210 C
Initial Layer Temp: 210 C
Build Plate Temp: 0 C
Print Speed: 20mm/s
Infill Speed: 20mm/s
Wall Speed: 10mm/s
Initial Layer Speed: 5mm/s
Enable Retraction: checked
Retraction distance: 5mm
Retraction Speed: 25mm/s
Music:
O’ tannebeum - by, ninjoi
• Copyright Free Christmas Music!
_____________________________
Also shown in this video:
Desiccant: https://www.amazon.com/dp/B07HRNJNXT?...
Fairy Lights: https://www.amazon.com/dp/B077N8J77P?...
Glue: https://www.amazon.com/dp/B000Y3LHXW?...
3d Pen: https://the3doodler.com/collections/c...
3d Pen Filament: https://the3doodler.com/collections/a...