Using the Picoscope and Serial Decoding to Analyze CAN Bus Data

Testing Resistance on the CAN Bus Network

Testing Variable Valve Timing Operation by Looking at Cam and Crank Signals (Picoscope)

Looking at Cam and Crank Position Signals to Verify Timing (Good Test For Variable Valve Timing Too)

Using Data Logging to Analyze Volumetric Efficiency

Using Data Logging to Analyze Data for Mass Airflow, Fuel Trims, and Lambda Sensors

Setting Up the OBDLink MX+ for Data Logging

Example of a Bad In Cylinder Pressure Waveform (2014 Honda Pilot Lack of Power-Backpressure)

Diagnosing Engine Performance Issues Using an In Cylinder Pressure Transducer (Detailed Analysis)

Using the Picoscope NVH to Diagnose a Vibration (2004 Ford Expedition)

Diagnosing a Misfire 2006 Ford F150 5.4L Using the Crank Sensor and Picoscope Math Channels

How to Set Up Your NVH Toolkit and Software (OBDLink MX+ as Passthrough)

Looking at Current Draw of DC Motors Using a Picoscope (2010 Malibu Power Windows)

CAN Bus Diagnostics 3 (shorts and opens on module with no termination resistor) 2007 Toyota Camry

CAN Bus Diagnostics 2 (Opens and Shorts) 2007 Toyota Camry Using the Picoscope

Diagnosing CAN Bus Networks with Picoscope (Shorts and Opens) On A 2013 Ford Fiesta

Testing for Poor A/C Performance/ Air Not Blowing Cold Enough/ How to Test a Relay

Diagnosing Bad O2 Sensors, Lean Codes, Random Misfire 2002 Chevy 6.0L

P0300 Random Misfire Code, Using the Picoscope with a Pressure Transducer

Fun Prank!!! How To Wire Someone’s Horn To Their Blinkers.

Turning a Brake Rotor On a Brake Lathe

Turning a Brake Drum On a Brake Lathe

How to calibrate a micrometer

How to measure a brake drum using a brake drum micrometer.

How to measure brake rotor thickness and thickness variation.

How to bench bleed a brake master cylinder.

How to cut, bend, and flare brake lines.

How to properly torque lug nuts.

How to use a 2 post symmetrical lift to raise a car.

How to use a 2 post asymmetrical lift to raise a car.