If your 2005-10 Honda Odyssey's battery dies overnight and the power sliding doors aren't closing properly, chances are that the latch/closer assembly isn't working properly. In this video, I show you the complete start to finish process of removing the latch, cleaning and re-lubricating it, and then putting everything back together. Of course, you can just install a new latch assembly if you don't mind the extra cost.

Notes:
At 10:25 I say that the top bolt can't fit through the whole, but it does actually fit through the whole. However, removing it makes the latch much easier to maneuver out.
At 20:28 I put the bolts back in the wrong holes. The one with the big washer goes on the bottom, and then I think the one with the slightly larger flange goes on top.
At 29:14 I say something about "it was this door that I fixed." Well, I fixed both doors but only showed you guys the passenger's side. lol

I'm planning on making an update video after this one ticks past a full year or so. Sooner if they stop working properly. Stay tuned!


Time Stamps:
0:00 Intro
0:22 How it happens
1:35 Tools and supplies you'll need
2:05 Nice visual of how to remove the handle retention clip
2:39 Me struggling to remove the door handle
3:17 Plastic window trim removal
3:57 Door trim panel removal
4:40 Plastic weather barrier removal
6:55 Start disconnecting cables and such
9:12 Remove the bolts that hold in the latch
10:40 The really tricky part: removing the latch assembly
10:44 Remove the plastic shield from the latch
12:42 Disconnect the actuation cables
13:26 Demonstrating the gummed-upness
14:15 Loosen up the latch's components
15:35 Clean up the dirty oil (compressed air is nice for this)
17:00 Oil up all the moving parts
17:15 Put it all back together!
24:28 Handy GooGone trick for putting the weather sheild back on
25:55 Continue reassembly
28:31 Testing it out
28:44 Moment of truth for parasitic drain