They said this was impossible - Can be installed on a FULLY PRESSURIZED water line in less than 10 minutes, STOPPING the flow of water instantly! No soldering, no crimping, no special tools needed! Stop the flow of water when you main water valve is stuck or has failed or doesn't exist. This is truly unbelievable! Be sure to watch the end where I take one apart so you can see the magic behind this marvel.

Isolator Valve 1/2" https://amzn.to/3YmkHcp
Isolator Valve 3/4" https://amzn.to/3DK02p2
Isolator Valve 1" https://amzn.to/3OK7aYU

As an Amazon Influencer, I earn from qualifying purchases

This video, description and comments contain affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows us to continue to make videos like this. Thank you for the support

Disclaimer:Due to factors beyond the control of Silver Cymbal, I cannot guarantee against improper use or unauthorized modifications of this information. Silver Cymbal assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Silver Cymbal recommends safe practices when working on machines and or with tools seen or implied in this video. Due to factors beyond the control of Silver Cymbal, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Silver Cymbal.