Build all 6 of these beautiful rustic dining room chairs for less than $100! This video goes through a detailed “how to” tutorial of how to make 6 dining room chairs quickly and affordably. If you decide that you only need 4, simply make 2/3 the cuts that I mention in the video and you’ll be able to easily do so. If you build 4 chairs, you could potentially spend around $50 if you shop around for the lumber and have some of the hardware already lying around. I have a detailed material listing in the first minute or so of the video. Anyone who watches this should very easily be able to build these. Chairs are a little more labor intensive than a table, but building them yourself can save you a lot of money. Check out my video, and you’ll see that you can build them too!

Check out my NEW DIY MAN Merchandise here: http://www.diyman.store/

Please consider supporting this channel by becoming a Patron. Loyal Patrons will receive official DIYMAN merchandise! Check it out here:
  / diyman  

Recommended tools:

The links below are affiliate links which I can earn money through purchases made by viewers. Please consider purchasing products through these links to Support DIYMAN. I use these funds to improve my videos’ quality and quantity. Thanks for your support.

Drill/impact gun

https://www.amazon.com/gp/product/B01...

Miter saw

https://www.amazon.com/gp/product/B01...

Pocket hole jig

https://www.amazon.com/gp/product/B01...

18 gauge nail gun

https://www.amazon.com/gp/product/B01...

Circular Saw

https://www.amazon.com/gp/product/B00...

Jigsaw

https://www.amazon.com/gp/product/B00...






Material list:
2x10s 10ft 2pcs
1x3s 8ft 8pcs
2x2s 8ft 6pcs
2x4s 8ft 8pcs
2 pints of stain
1 pint of polyurethane
2 qt of white oil based paint
300 2” pocket screws
Wood glue


Cut list:
2x10s seat top
6 @ 20”
Angle edges from 20” down to 18 3/4”
(In other words, mark 5/8” in from the two back corners and make a line from those to the two front corners)
6 @ 18 3/4”
Angle edges down from 18 3/4” to 17 1/2”
(In other words, mark 5/8” in from the two back corners and make a line from those to the two front corners)
Notch the ends 2” deep and 1 1/2” wide

2x4s Legs and Chair back
12 Pieces at 38.5" (watch the video for details on cutting these out)
12 Pieces at 16.5" These will be the front legs (Rip these down to 2" wide)

2x2s seat back and bottom bracing
18 @ 14.5”
12 are for the chair back (horizontal supports)
6 are for the bottom bracing (middle) put one pocket hole on each side of these 6.
12 @ 15”
These will be trimmed to fit and pocket holes will be added. Watch the video for details.


1x3s bracing for seat top and chair backing
12 @ 14.5” (front and back seat bracing)
Need 2 pocket holes on each side
12 @ 13.5” (side bracing)
Need 2 pocket holes on each side
18 @13 inches (vertical portions of the chair back)

Note: As an Amazon associate, I earn from qualifying purchases