In this video I print several types of filament and run them on my homemade tensile testing machine.

I compare carbon fiber reinforced nylon to a number of other 3D printing materials.

Discord Channel:
  / discord  
Here are the materials I used in this test:

Carbon Fiber Reinforced Nylon (Sainsmart Carbon Fiber Filled Nylon Filament)
https://amzn.to/3wtduZT

UHU Glue Stick (works great on PETG and Nylon, not good with PLA)
https://amzn.to/3C6hKA0

Air Fryer (I got a Gourmia Brand from Costco, but anything 5 quarts/liters and up will work. Minimum temperature setting and maximum timer setting could be important to you. Mine only goes down to 80C, but others go as low as 40C, which would make it useful for drying petg, tpu, and pla):
https://amzn.to/3oagve2
https://amzn.to/3o8gmrz (goes a low as 40C)

Leg actuator from Fully Jarvis desk (same as my personal desk):
https://amzn.to/3D0OkUX

Crane Scale:
https://amzn.to/3040oq7

LIGHT GREY PLA (OVERTURE PLA)
https://amzn.to/3CZn0qe

Red PLA+ (HATCHBOX PERFORMANCE PLA)

Orange PETG (Duramic PETG)
https://amzn.to/3kkMmaK

Black TPU (Priline TPU, seems like 95A durometer)
https://amzn.to/3kgm1KL



Introduction: (0:00​)
First Prints: (1:28)
High-Temp Filament Dryer: (3:12)
Materials Tests: (4:13)
Data Analysis: (9:18)