Full Build Video:    • Amazing DIY Infinity Wing Build - 3DA...  

This is the X-100 Infinity Wing from https://www.3daeroventures.com

Thank you so much for watching!

If you like videos like this, consider buying me a coffee, it really supports me: https://www.buymeacoffee.com/troymcmi...


See what else I am working on:   / troymcmillan_rc  
  / troymcmillan_rc  


#3DPrinted​,#RCAirplane​, #ItFlies​

STL Files: https://www.3daeroventures.com/shop/i...
Landing Gear Upgrade: https://www.3daeroventures.com/shop/i...

Products Mentioned:
Twotrees Saphire Pro 3D Printer - https://www.aliexpress.com/item/40000...
LW-PLA: https://www.3daeroventures.com/shop/m...
CA Glue: https://amzn.to/2J8EvNW​
CA Accelerator: https://amzn.to/3fpbycz​
4S 4000mAh Battery: https://amzn.to/37fulV7​
AR620 Receiver: https://amzn.to/3j4PbK4​
DX6 Transmitter: https://amzn.to/3l6NFsD​
3pin wire assortment: https://amzn.to/3l1xNYt​
XT60 connector: https://amzn.to/3iyZWnf​
2mm push rod ends: https://amzn.to/3nnjD4U​
Z-Bend pliers: https://amzn.to/34mA0rt​
Hobby Knife: https://amzn.to/3eYOYJq​
#11 blades: https://amzn.to/3vTJZ2W​
Hot knife: https://amzn.to/34AGOB1​
Drill Bits: https://amzn.to/3nIJzrx​
Build Mat: https://amzn.to/3vJmauw​
Carbon Rods: https://www.readymaderc.com​



*These are the settings I used for my Twotrees Sapphire Pro 3D Printer with PLA. These settings are not going to work with every printer, or every PLA. Printers have different length bodin tubes, and PLA’s have different melting points. These may not work exactly for you, but should give you a good base to start with if you have a similar size printer. Good luck!

Profile 3 Cura Settings:
Quality:
Layer Height – 0.25
Line Width – 0.3
Shell:
Wall Line Count – 1
Infill:
Infill Density – 5
Infill Pattern - Gyroid
Material:
Printing Temperature – 215
Build Plate Temperature – 60
Flow – 100
Speed:
Print Speed – 100
Outer Wall Speed – 35
Inner Wall Speed – 35
Travel Speed – 80
Travel:
Enable Retraction – Checked
Retract at Layer Change - Checked
Retraction Distance – 5
Retraction Speed – 25
Retraction Extra Prime Amount – 0.5
Combing Mode – all
Cooling:
Enable Print Cooling – Checked
Fan Speed – 50
Mesh Fixes:
Union Overlapping Volumes – Checked
Special Modes:
Surface Mode – Normal
Experimental:
Slicing Tolerance – Middle










Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!!