In this video I go over how I added a rigging tube to a Yamaha F70 outboard. It's not really a tube, its actually spiral wrap. As best I can tell, Yamaha does not offer a rigging tube grommet for the F70 so I went with the Spiral wrap. Although it's not as pretty as a commercial rigging tube it still server the two main functions of having one:

1) it Protects the cables and rigging components
2) It Neatens everything up

Since I was rigging this engine from scratch, I could have added a rigging tune but wanted to try the Spiral wrap. I think the Spiral wrap gives you a clean solution without having to disconnect your engine's electrical and control cables.
I used large shrink wrap on the end in this case but may transition to dual sided velcro. We'll look into that in the future.

Below are paid affiliate links to the tools and items I used in this video:
2" Spiral Wrap: https://amzn.to/3siyCEf
3", 80mm 2:1 Heat Shrink: https://amzn.to/3YGZWIl
4" 100mm 2:1 Heat Shrink: https://amzn.to/45zqoWD
Dual Sided Velcro: https://amzn.to/47GF9bU

00:00 Introduction
01:00 Installing the Spiral Wrap
03:38 Next Steps
04:30 Cutting the Tube
05:05 Adding the Shrink Wrap
06:26 Installing the Floor Plate
07:30 Testing the Fit and Clearance
08:18 Wrapping it Up (No Pun Intended)

#yamaha
#outboards
#rigging