In this video I'm experimenting with a 3D print, alcohol ink, resin and glitter.
Please don't forget to like, subscribe and comment. Keep on scrolling for a list of products that I used. And as always, thank you for watching.

***Disclosure: I only recommend products I would use myself and all opinions expressed here are my own. This description box may contain discount codes and affiliate links that at no additional cost to you. I am in no way responsible for the way you use your products. Follow all safety instructions of the manufacturers, I cannot be held liable for any misuse or reactions to products I recommend and use myself.

LETS GET SOCIAL!
You can follow me on GMI's superstars page
  / gmisu.  .
or my FB Group -   / 56479.  .
or
IG - @its_acraftthing

SUPPLIES

Glitter
Glitter Color used - Ultra Fine Shimmer
Glitter - https://glittermakesit.com/collection...
Enter code "itsacraftthing30" for a 30% off entire glitter order!

3D print of your choice. I designed a simple coaster using Kingroon white PLA and printed on a Bambu Lab A1 printer.
Epoxy of your choice
Paper towels
Soft bristle brush
Alcohol inks - https://www.amazon.com/Alcohol-Ink-Se...

Tools typically used - Craft knife, 120 grit sandpaper and 180 to 220 for finer sanding after the 120. Scissors, weeding tools, transfer tape. 91% alcohol, paint or makeup brushes, mod podge, dusk mask, chemical mask, gloves.

As always, I try to list everything I use but if I forget something, please do not hesitate to ask in the comments below.