Published On Mar 7, 2024
Link Here: https://www.printables.com/model/7967...
Per the printables page:
Load the .3mf in Bambu Studio. Set flushing volumes to 800 both ways. Set flow for the interface material at 105%
I used PETG and PLA Plus
Note the modifier layer on either side of the middle most layers, this is to force the creation of top and bottom layers of the base grid, otherwise the slicer will treat the intermediate layer as just a modifier with infill the whole way through.
I also included the base model that I split in creation of the .3mf
show more