Follow along instructions for installing the PitStop extruder.
Assembly notes:
1. When assembling the X and Z axes, make sure the carriage can slide easily. If there's binding, it means that some part is crooked (carriage?) or something is not installed correctly.
2. The X-ends (if replaced) require HEX nuts.

Written instructions not available.
Assembly overview video coming up.

Encountered issues? Seek help at   / mihai   (knowledge base hasn't been built yet)

Survey/feedback form (after installation): https://forms.gle/zhSheA5U9qhkYgDu5

Jump to section:
0. 0:00 Introduction
1. 1:17 Disclaimer and rollback
2. 1:58 Initial checks
3. 7:02 E-axis disassembly
4. 8:56 Partial X-axis disassembly
5. 9:48 X-ends replacement (optional)
6. 11:00 Motor and blower wire extension (optional)
7. 11:37 Carriage mounting
8. 13:23 X-axis reassembly
9. 14:22 Z-axis reassembly
10. 18:03 PTFE tube replacement
11. 18:49 Filament sensor installation
12. 21:47 Extruder body and cable holder mounting
13. 23:19 X-axis bearing tightening
14. 25:43 Extruder fan replacement
15. 29:57 Mounting the fans
16. 32:11 Fan duct and motor mounting
17. 34:06 Adjust the hobbed gear
18. 34:34 Magnet installation
19. 38:43 Bondtech idler installation
20. 40:36 Pneumatic fitting installation
21. 41:08 Front cable management
22. 45:52 Back cable management
23. 48:28 Belt installation
24. 50:33 Pinda adjustment
25. 51:24 Final checks
26. 54:33 Afterword

Project page https://mihaidesigns.com/pitstop


Patreon   / mihaidesigns  
Buy me a coffee http://mihaid.com/coffee
Instagram:   / ​  
https://mihaidesigns.com/​

#mihaidesigns