Published On Jan 12, 2024
This plane was designed by Kyle G. His facebook page can be found here
/ 384918717530863
This is the 64mm Viggen. I printed it in prefoamed PLA instead of LW PLA to see if there is a difference in weight and flight. I ran out of Yellow halfway through the print so finished it in lime green. I pained the cockpit cover silver. Parts should be here by mid next week so stay tuned.
The parts are listed here but can also be found on his FB page created by user Chris P.
Servos
Wings - MG 90S servos (or plastic)
Canard’s or thrust vectoring: 3.7g servos
Servo Extension
2 10” Servo extensions
Motor
50 FMS 50 or the hobby fun Amazon (any 700g thrust or more)
64 https://www.amazon.com/dp/B09L672WXB (any 900g thrust or more)
70 TBD
90 TBD
ESC
50A preferred. 40A is OK if using efficient motor/fan
Control Hinges - Needs to fit 30mm x 25mm x 1mm slot
CA hinge
3d print PLA
RX (receiver)
Any 4 channel or more depending on need
Battery
4s 1300, 1550, or 2200
Pushrods
1.2mm pushrod wire
Magnets
https://www.amazon.com/TRYMAG-Neodymi...
The mirage 64 and 70 run 12mm diameter. The Viggen 64 and 70 run 8mm and the 50 runs smaller
Glue
Normal or foam safe CA (super glue/krazy glue)
EVA glue (Foam tac) as an alternative
Please be sure to hit that like button.
@BambuLab #3d #3dprinting #3dprinter