Fitting a PEI bed can be a great upgrade to your 3d printer but, like anytime you change a part on your printer, there is a right and a wrong way to do it.
In this video i'll quickly show you how to fit a flexible PEI Bed with an adhesive backed magnetic plate the right way to make sure you don't get bubbles or high spots that will ruin your first layers.

Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)

*PEI Beds - Most common sizes*

220x220mm (Anet A8)
https://amzn.to/3G8QGFr

235x235mm (Ender 3)
https://amzn.to/3FCOynS

310x310mm (CR10, Sidewinder)
https://amzn.to/3FJyFMo

410x410mm (Cr-10 S4, Anycubic Chiron)
https://amzn.to/3HX1OX8

Acetone
https://amzn.to/3hFG4o7

IPA
https://amzn.to/3HSMT05

..............................................................................................................................................................

BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.

https://www.buymeacoffee.com/rickyimpey

You can also use the YouTube 'Thanks' button above if you prefer.
...............................................................................................................................................................