Today in the world of 'printer unboxing and first impressions' series we have the Sunlu S8 3D printer. I've had this one sat waiting to be unboxed for a while now. Is it worth the wait? We shall see...

As usual, in this video, I show you what you can expect out of the box, demonstrate the assembly and give a few first comments on the printer.

This printer has an RRP of $200, but they often have deals and coupons. There was a spin the wheel discount when I visited the site, came out at around £130! Quite a bargain for the size.

I hope you enjoy the video, don't forget to LIKE and SUBSCRIBE :D

Spec check:
- Build Volume: 310 x 310 x 400mm
- Dual Z-Axis Support Rods
- Mostly Pre-assembled (you'll see from the video this is true!)
- Upgraded Glass Bed
- Bowden
- Filament Run out sensor

00:00 Introduction
00:44 What's in the Box
02:30 Setup: Gantry Assembly
03:52 Tighten Bed
04:34 Tighten Head
04:50 Setup Spool Holder
06:30 Check Voltage
06:49 First Comments
08:20 Setup Complete
08:52 Questions for YOU!
09:27 Q3 / Giveaway
10:33 B-Roll

If you enjoyed this video and want to support me here's the link to buy me a coffee: https://www.buymeacoffee.com/callumcoles or https://paypal.me/callumcoles

Equally, if you are in the UK and want to support British manufacturing, why not try 3DTomorrow Filament. We're working on new colours and product lines all the time: https://3dtomorrow.com

#SunluS8 #3DPrinting #Unbox