How to install Pergola Star , step by step

00:00 Mount the wall-brackets.
00:08 Mount the rafters onto the brackets and also the general regulator.
00:22 Assemble the parapet.
00:48 Mount the rafters onto the pillar.
01:13 Before placing the tube, end all the runners in the upper side of rafters.
01:20 Tube fitting.
01:29 Before placing the motor inside the tube, move a bit all the runners to the lower side of rafters.
01:40 Place the motor into the tube. Motor’s cables must be downside.
01:44 Place the restraint plate of the motor which you will find into the package.
02:00 Fit the support beam onto the cover material. Attention, the side of the support beams must be according to the enclosed sketch.
02:22 Stretch the cover material properly with the screws and the plugs that you will find into the package.
02:28 Pierce the cover material from one side to another, in the spots that the supports beams are already drilled.
02:34 Place the support beam onto the guides.
02:39 Repeat the procedure until the support beams placed onto the guides.
02:50 Place the last wide support beam onto the cover material and move all the support beams in the highest side of the guide.
03:08 Place the wide support beam onto the guides.
03:30 Open the Star pergola.
03:40 Open a small hole onto the cover material exactly above the beam that you will choose to have lights and then pull out a pair of cables.
03:50 Pass the cable through the plastic cap of the beam and connect it with the spo-light.
04:00 Connect the next spot-light with the cable that you will find enclosed.
04:09 Fasten the light onto the beam.
04:26 After fastening all lights, cover the cables with the special profile.
04:33 Repeat the same procedure for the other beams that will have lightning system.
04:42 Place the parapet and support beam plugs.
04:54 Install the rear profile into the blades of rafters and then adjust the aluminum cover in it.
05:12 Put the iron blades into the front profile and screw it onto the drivers after you adjust the aluminum cover in it.
05:59 Adjust the motor limits.
06:04 Pergola Star has been successfully installed.

http://www.metaform.gr/products/star?...